Self Regulating Heating Cables- Accessories

Accessories for all products mentioned in commercial heaters segment are mentioned below:

1. Hanger Bracket & Cable tie.

The Hanger Bracket Kit is used to hold the heating cable in place at the top of downspouts.

2. Roof clip
The Roof Clips are used to secure heating cables to shingle and metal seam roofs and gutters.

3. Termination kit & Heat shrink sleeve
The Power termination kit Splice heat shrink sleeve Splice is suitable for use with self-regulating heating cables to make splice, end seal connections.

Clamp tie
Heat-shrinkable tubes
Mastic strips
Insulated bus wire crimps
Uninsulated braid crimp

4. GFCI
To minimize the danger of fire from sustained electrical arcing, ground fault protection equipment must be used on each heating cable circuit.

5. Two – Way Splice Kits
The Two way splice kit is used to create an inline connection with 2 self-regulating cables. This application is found on tracing runs for water lines as well as on roof and gutter applications.

6. Three – Way Splice Kits
The Three way splice kit is used to create a “T” connection with 3 self-regulating cables. This application is found on tracing runs for water lines as well as a replacement for downspout runs in roof and gutter applications.

7. End-Kit
End-Kit durable corrosion resistant enclosures provide premium protection for your electrical end seal.

8. Thermo Glass Adhesive Tape
The heating cable is cut to length at the job site and attached to the pipe with glass tape.

9. Thermo Aluminium Foil Tape
The aluminium adhesive tape is used to fix the heating element on the pipe.

10. Clamp tie
Clamp tie secure and maintain the proper position of the cables during installation.

Self Regulating Heating Cables- Accessories

Not sure where to start? Try our products